Bed and rug: choosing a size that keeps the border visible
A rug under the bed structures the bedroom and dampens footfall noise, but it only works if its size suits the bed. If it is too small, it disappears almost entirely beneath the frame, leaving a narrow strip that looks accidental. If it is too large, it runs into wardrobes or doors. For hotel rooms, showrooms in retail and private bedrooms, it is therefore worth planning the dimensions together before ordering.
How wide the visible border should be
As a guide value, the rug should extend about 50 to 70 centimetres beyond the bed on both long sides. This way, both feet land on a textile surface when getting up, and the border is wide enough to be perceived as a deliberate area. At the foot end, 30 to 50 centimetres are generally sufficient, provided no bench stands there. Narrower borders of less than about 30 centimetres usually look like an oversight. Anyone using Baroque furniture with a carved frame should allow a rather generous border so that the frame does not appear cramped.
Deriving the rug size from the bed width
The calculation is simple: bed width plus twice the desired border. Bear in mind that the outer dimensions of a bed with frame and headboard can be considerably greater than the mattress width, by 20 centimetres or more in the case of sweeping models. For a double bed with a lying surface of about 180 centimetres, this often results in a rug width of around 300 centimetres. When choosing from the Beds range, you should therefore always work from the overall dimensions of the frame and not the mattress size. Bedside tables generally stand either entirely on the rug or entirely beside it.
Fully under the bed or only two thirds
Two arrangements are common. If the rug lies completely under the bed and the bedside tables, the result is a calm, continuous surface; this requires a large format, and part of the material is never seen. Alternatively, the rug starts only in front of the bedside tables and covers roughly the lower two thirds of the bed length. This saves area and allows a wider border at the foot end. In narrow rooms, two runners along the long sides may be the sensible option instead. With a deep pile, the second variant creates a slight difference in height between head and foot end, which is barely noticeable with flat rugs.
Pile, bed feet and cleaning in daily operation
Heavy beds leave permanent pressure marks in deep pile, and narrow feet sink in more than wide plinths. For commercial use, flat-woven or short-pile rugs are therefore generally the more practical choice; they are also easier to vacuum. Check whether the cleaning equipment fits under the bed, as the area beneath the frame collects dust. A non-slip underlay prevents the visible border from rippling or becoming a trip edge. Doors should be able to swing over the rug without dragging; measure the swing area before ordering.
Related: Benches, Console Tables, Armchairs. The full range: Baroque furniture.
Read more: Placing consoles in pairs: symmetry in the entrance area, Leather armchairs: plan for patina from the start, Pedestal dining table: legroom at every seat, Bed with Low Footboard Bench: Visually Elongate the Room, Sofa for the Reception Area: Combining Representation and Comfort